Panasonic SC-CMAX5

15
(ENG) RQT0A53
Others
This function automatically switches off the system
when you do not use it for approximately
20 minutes.
1 Press [SETUP] repeatedly to select “AUTO
OFF”.
2 Press [3, 4] to select “ON” and then press
[OK].

≥ To turn the function off, select “OFF” in step 2.
≥ When connected to a Bluetooth
®
device, the function does
not work.
When “SC-CMAX5” is selected from a paired
Bluetooth
®
device’s Bluetooth
®
menu, this unit will
turn on automatically from standby mode and
establish a Bluetooth
®
connection.
1 Press [SETUP] repeatedly to select
“BLUETOOTH STANDBY”.
2 Press [3, 4] to select “ON” and then press
[OK].

≥ To turn the function off, select “OFF” in step 2.
Occasionally, Panasonic may release updated
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
∫ Checking the software version
The version of the installed software is displayed.
Press [SETUP] repeatedly to select “SW VER.” and
then press [OK].
≥ Press [OK] to exit.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
Preparation
Press [AUX] to select “AUX 1” or “AUX 2”.
∫ To set the code to “REMOTE 2”
1 While pressing and holding [USB] on the unit,
press and hold [AUX] on the remote control
until the unit’s display shows “REMOTE 2”.
2 Press and hold [OK] and [USB] on the remote
control for at least 4 seconds.
∫ To set the code to “REMOTE 1”
1 While pressing and holding [USB] on the unit,
press and hold [USB] on the remote control
until the unit’s display shows “REMOTE 1”.
2 Press and hold [OK] and [ ] on the remote
control for at least 4 seconds.
Auto off function
Bluetooth
®
standby
Software update
Remote control code
SC-CMAX5_PP~RQT0A53-Y_ENG.book 15 ページ ２０１５年６月１２日 金曜日 午前１０時２３分