DAB (continued)
Press the [DAB SECONDARY] to select the secondary
service.
“ ” is displayed if there is a secondary service broadcast.
The secondary services are selected each time the button
is pressed. The primary service is returned to after the last
secondary service.
Presetting
Display
Turning automatic clock
adjustment function on
Press [DISPLAY] to select the display.
The information scroll through the display.
Each time you press the button:
Dynamic label
(information about the
broadcast)
PTY display
(program type)
Ensemble label
(the name of the
ensemble)
Frequency display
Time display
To adjust the time information during DAB broadcasting
and automatic time adjustment.
1 Press [DAB MENU] to enter menu mode.
2 Within 10 seconds, press [e,r, ALBUM] to select
“AUTO CLOCK ADJ.” and then press [OK].
3 Within 10 seconds, press [e,r, ALBUM] to select
“ON ADJUST” and then press [OK].
Select “OFF ADJUST” to turn the automatic clock
adjustment function off.
To exit
Press [DAB MENU] again.
To improve reception by adjusting the antenna while
monitoring signal quality on the display.
1 Press [DAB MENU] to enter menu mode.
“SCAN FAILED” appears if no stations are memorized.
If this occurs, adjust the antenna and try Auto scanning
or change the Auto scan frequency range. (➡ page 13)
2 Within 10 seconds, press [e,r, ALBUM] to select
“SIGNAL QUALITY” and then press [OK].
3 Press [e,r, ALBUM] to select the frequency.
To exit
Press [DAB MENU] again.
In order to enjoy the new stations after adjusting the
antenna, it is necessary to perform Auto scanning and
update the station memory.
Frequency
block
Frequency
Reception quality
0 (poor) - 8 (excellent)
Up to 20 channels can be set.
1 Press [u/t] or [y/i] to select a station.
2 Press [PROGRAM].
3 Press the numeric buttons to select a channel.
4 To preset more stations, press [PLAY MODE] to
select “STATION TUNE” and then repeat steps
1 to 3.
You cannot preset stations when the station is not
broadcasting or when you are selecting a secondary service.
1 Press [PLAY MODE] to select “PRESET TUNE”.
“PGM” is displayed.
2 Press [u/t] or [y/i] or numeric buttons to
select a channel.
Selecting a preset channel
Presetting channel
Note
Note
Note
Listening to the secondary service Checking the DAB signal quality
To Next Page
Loading...
Need help?
General
