The SLEEP timer can turn the unit off after a set time.
Press [SLEEP] to turn the SLEEP function on/off.
Each time you press the button:
g To check the remaining
time
Press [SLEEP] once
The play timer and sleep timer can be used together. The
sleep timer always has priority. Be sure not to overlap
timer settings.
•
This is a 24-hour clock.
Press [CLOCK/TIMER] to set the clock.
Press [u/t] or [y/i] to select the time
within 5 seconds.
(Press and hold to change the time faster.)
Press [CLOCK/TIMER] again.
g To display the clock for few
seconds when the unit is on
or in standby mode
Press
[CLOCK/TIMER]
Note
Reset the clock regularly to maintain accuracy.
Note
Timer
To Action
change the
settings
Repeat steps 1 to 4 and 6.
change the source
or volume
Press [z, PLAY] to clear
zPLAY indicator from the
display.
Make changes to the source or
volume.
Perform steps 5 and 6.
check the settings
(when the unit is
on or in standby
mode)
Press [CLOCK/TIMER] repeatedly
to select zPLAY 1, zPLAY 2 or
zPLAY 3.
cancel
Press [z, PLAY] to clear the timer
indicator from the display.
The timer will start at the preset time, with the volume
increasing gradually to the preset level.
The timer comes on at the set time every day if the
timer is on.
The unit must be in the standby mode for the timer to
function.
If you turn the unit off and on again while the timer is
functioning, the finish time setting will not be activated.
When external unit is selected as the source when
the timer comes on, the system turns on and engages
external unit as the source. If you wish to playback
from the portable audio equipment, activate the
equipment’s play mode and increase the volume. (See
the portable audio equipment’s instruction manual.)
•
•
•
•
•
Setting the clock
Sleep timer
Play timer
Note
You can set the timer to come on at a certain time to
wake you up. This unit offers 3 optional play timers.
Preparation:
Turn the unit on and set the clock. (➡ see above)
Prepare the music source (disc, radio, iPod or AUX)
and set the volume.
Press [CLOCK/TIMER] repeatedly to select play
timer.
Within 5 seconds, press [u/t] or [y/i] to
set the starting time.
Press [CLOCK/TIMER] to confirm.
Repeat steps 2 and 3 to set the finishing time.
To activate the timer
Press [z, PLAY] repeatedly to turn on your desired
play timer.
Press [^] to turn off the unit.
•
•
Sleep timer indicator
OFF (Canceled)
CLOCK
zPLAY 1 zPLAY 2 zPLAY 3
Original display
Play timer indicator
Start time
“ON” is displayed
Finish time
“OFF” is displayedPlay timer indicator
To Next Page
Loading...
Need help?
General
