6
TQBJ0987
Connections
≥ Tape the antenna to a wall or column in a position with the least amount of interference.
≥ If radio reception is poor, use an outdoor antenna (not supplied).
1 Connect an external music device using an audio
cable (not supplied).
≥ Plug type: ‰3.5 mm stereo
2 Press [RADIO, EXT-IN] repeatedly to select “AUX”
and start playback on the connected device.
∫ To select the sound input level of the
external device
1 While in AUX mode, press [SOUND] repeatedly to
select “INPUT LEVEL”.
2 Press [2, 1] to select “NORMAL” or “HIGH” and
then press [OK].
≥ The factory default is “NORMAL”.
≥ To improve sound distortion when “HIGH” is selected, select “NORMAL”.
≥ Switch the equalizer off or turn the volume of the external device down to reduce the input signal. High level of input signal will
distort the sound.
≥ For details, refer to the operating instructions of the device.
Connect an external music device
Connect the antenna.
Be sure to tighten the nut fully.
To a mains socket
Connect the AC mains lead after all other
connections are completed.
This unit consumes a small amount of AC power
(l 19) even when turned off.
≥ In the interest of energy conservation, if you will not be using
this unit for an extended period of time, unplug it from the
mains socket.
≥ Some settings will be lost after you disconnect the system.
You have to set them again.
DAB indoor antenna (supplied)
Adhesive tape (not supplied)
FM indoor antenna (supplied)
[HC402]
[HC400]
This unit can receive DAB/DAB+ and FM stations with the DAB antenna.
Adhesive tape (not supplied)
[HC400]
(Australia and New Zealand only)
Adhesive tape (not supplied)
FM indoor antenna (supplied)
AM loop antenna
(supplied)
AC mains lead (supplied)
Audio cable
(not supplied)
SC-HC400_402-EGEBGN~TQBJ0987.book 6 ページ ２０１７年３月１６日 木曜日 午後７時５２分
To Next Page
Loading...
