14
RQTX1267
With this function it is possible to check the signal reception
quality of a selected frequency.
If the reception quality is poor, try adjusting the antenna.
Preparation
≥ Press [EXT-IN, RADIO] repeatedly to select “DABr”.
1 Press [RADIO MENU] repeatedly to select
“SIGNAL QUALITY”.
2 Press [2, 1] to select the frequency.
≥ After displaying the frequency, the current reception quality
is displayed.
3 To continue checking the quality of other frequencies
Press [2, 1] again and select the desired
frequency.
To exit
Press [RADIO MENU].
≥ If the antenna has been adjusted, perform Auto scanning and
update the station memory.
(> below)
When new stations are added or when the antenna has been
moved, reperform the Auto scan.
1 Press [RADIO MENU] repeatedly to select
“AUTOSCAN” and then press [OK].
2 While “START ?” is flashing,
Press [OK].
≥ When updating the memory with Auto scan, preset stations will be erased.
Preset them again (> right).
≥ When a frequency is tuned using Auto scanning, the ensemble corresponding
to the frequency is displayed for approximately 2 seconds.
≥ Total stations received is displayed for approximately 2 seconds.
On this unit, there are 2 ways of selecting the desired station.
Preparation
≥ Press [EXT-IN, RADIO] repeatedly to select “DABr”.
≥ Make sure that the initial settings are made.
(> 13)
To select by station (alphanumeric order)
Press [6] or [5] to select a station.
To select by preset
Press [:] or [9] to select a preset station.
≥ Alternatively, press the numeric buttons to select the channel.
≥ To select by preset, make sure that stations have already been preset
manually. (> below)
You can preset up to 20 DAB channels.
Preparation
≥ Press [EXT-IN, RADIO] repeatedly to select “DABr”.
1 Press [6] or [5] to select the station.
2 Press [PROGRAM].
3 Press the numeric buttons to select the
channel.
≥ You cannot preset stations when the station is not broadcasting or when the
secondary service is selected.
≥ The station occupying a channel is erased if another station is preset in that
channel.
If the station is providing secondary service, “ ” will be
displayed. It is possible to change between the primary and
secondary service.
Preparation
≥ While listening to the primary service.
1 Press [RADIO MENU] repeatedly to select
“SECONDARY” and then press [OK].
2 Press [2, 1] to select the secondary service
and press [OK].
≥ The setting will go back to primary service when changes are made (e.g.
frequency is changed).
Checking the DAB signal
reception quality
To re-Auto scan DAB stations
Listening to DAB stations
Presetting stations manually
Listening to the secondary
service
SC-HC55DB&35GN-RQTX1267-B.book 14 ページ ２０１１年２月１８日 金曜日 午後５時５８分
To Next Page
Loading...
