5
RQT7433
Other speaker setup options
Other speaker setup options
∫ Attaching to a wall
1 Drive a screw (not included) into a wall.
2 Fit the speaker securely onto the screw(s) with the hole(s).
≥The wall or pillar on which the speakers are to be attached should
be capable of supporting 10 kg (22 lb.) per screw. Consult a
qualified building contractor when attaching the speakers to a
wall. Improper attachment may result in damage to the wall and
speakers.
∫ Fitting speaker stands (not included)
Ensure the stands meet these conditions before purchasing them.
Observe the diameter and length of the screws and the distance between screws as shown in the diagram.
≥The stands must be able to support over 10 kg (22 lb.).
≥The stands must be stable even if the speakers are in a high position.
Wall or pillar
110 mm
(4
11
/32q)
Center speaker
Front speaker
Move the speaker so the screw is in this position.
60 mm (2
23
/64z)
Speaker stand
(not included)
Plate thickness plus 7 to 10 mm
(plus
9
/32z to
25
/64z)
Front speaker
30–35 mm (1
3
/16q–1
3
/8q)
‰7.5–9.4 mm (
19
/64q–
3
/8q)
8–11 mm (
3
/8q–
7
/16q)
e.g.
So that the speaker fits up against the wall
squarely, be sure to press the speaker cable
down into the groove.
In this position, the speaker will
likely fall if moved to the left or right.
e.g.
5 mm (
13
/64z),
pitch 0.8 mm (
1
/32z)
Attach the stands to
these metal screw
holes.
To Next Page
Loading...
