6
RQT7972
Simple setup
[HT933]
1 Attach the pipe to the base.
1 Thread the speaker cable through the base.
2 Insert the pipe.
3
Secure the pipe to the base.
Ensure the screws are
securely fastened by lightly
tightening the left and right
side screws alternately until
fully tightened. (The heads of
the screws protrude slightly
even if you have fully
tightened them.)
2 Attach the stand to the speakers.
≥
There is no difference between the right and left speakers and stands.
≥Using the polyfoam included with this unit may be convenient.
Ensure the stand is fastened on straight by lightly tightening the top
and bottom screws alternately until fully tightened.
∫ Front speaker height
(Assembled diagram)
3 Adjust the speaker height.
≥Check the screws you tightened in procedures 1 and 2 if the pipe
and speaker are loose.
e.g. Attaching the stand to the lower rear
STEP1
Front speaker assembly
2 Front speakers 2 Bases2 Pipes 4 Small screws4 Large screws
The supplied stands are specially designed for
attachment to Panasonic SB-PF920 front speakers.
Only use as indicated in this setup.
Lessen excess
speaker cable.
Thread the speaker
cable through here.
Cable
Groove
Holes for screws
Insert the pipe while gently
pulling on the speaker cable.
Rear side of base
Cable
Large
screws
Small screws
Front speaker
Polyfoam
Connection terminals
Mounting plate
You can also attach to the upper rear of the speaker.
The height of the speaker is indicated in the diagram on the
right when attaching the stand to the upper rear or lower rear of
the speaker.
For your reference
You can enjoy good acoustics by
adjusting the height of the speaker to
the height of the television so the
center positions of both are
approximately the same.
1,138 mm
(44
13
/16z)
Speaker
Base
968 mm
(38
1
/8z)
796 mm
(31
11
/32z)
625 mm
(24
19
/32z)
678 mm
(26
11
/16z)
Stopper
screw
Do not
remove.
You can adjust within this range.
Attach to lower
rear of speaker
Attach to upper
rear of speaker
Pipe
Stopper screw
Screw to stop mounting plate from
moving or sliding below this point.
1 Loosen the attached speaker mounting
plate screw until the attached speaker is
slightly loose and adjustable.
2 With one hand on the base and the other
holding the speaker adjust the height of
the speaker up and down.
≥After adjusting the height tighten the screw
on the mounting plate securely.
Be careful not to loosen the screw
too much or the speaker may detach
and fall.
Phillips-head screwdriver
Front speaker assembly
7972en-p03-31.fm Page 6 Tuesday, June 14, 2005 4:10 PM
To Next Page
Loading...
