EasyManua.ls Logo

Panasonic SC-HTB400

Panasonic SC-HTB400
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
TQBJ2216
Wireless Connections
Active subwoofer wireless connection
[HTB600]
Preparation
Switch on the main unit.
Check that the wireless link is activated.
WIRELESS LINK indicator
On: The wireless link is activated.
Off: The wireless link is not activated.
Blinks: The active subwoofer is trying to activate
the wireless link with the main unit.
Note:
The wireless link will be activated when the main unit and
the active subwoofer are both switched on.
The I/D SET button is only used when the main unit is not
paired with the active subwoofer. (~22)
Bluetooth
®
connection
You can connect and play an audio device
wirelessly through Bluetooth
®
.
Preparation
Switch on the main unit.
Switch on the Bluetooth
®
feature of the device
and put the device near the system.
Read the operating instructions of the device for
details.
Pairing a device
Preparation
If this system is connected to a Bluetooth
®
device,
disconnect it (~below).
1 Press [ -PAIRING].
If “PAIR” is shown, continue with step 3.
2 Press and hold [ -PAIRING] until “PAIR” is
shown.
3 Select “SC-HTB400” or “SC-HTB600” from
the Bluetooth
®
menu of the device.
The MAC address (e.g., 6C:5A:B5:B3:1D:0F)
may be shown before “SC-HTB400” or
“SC-HTB600”is shown.
If prompted for a passkey, input “0000” or
“1234”.
The name of the connected device is shown for
a few seconds.
Note:
You can pair up to 8 devices with this system. If a 9th device is
paired, the device that has not been used for the longest time
will be replaced.
Connecting a paired device
Preparation
If this system is connected to a Bluetooth
®
device,
disconnect it (~below).
1 Press [ -PAIRING].
2 Select “SC-HTB400” or “SC-HTB600” from
the Bluetooth
®
menu of the device.
Disconnecting a device
Press and hold [ -PAIRING] until “PAIR” is
shown.
Note:
This system can only connect to one device at a time.
When “BT” is selected as the source, this system will
automatically try to connect to the last connected device.
The Bluetooth
®
device will be disconnected when you select
another source.
htb600.400_TQBJ2216_en.fm Page 17 Thursday, May 14, 2020 2:22 PM

Related product manuals