Panasonic SC-MAX6000 - Remote Control and System Overview

5
RQT9979
5
SC-MAX6000
Put the speakers so that the tweeter is on the outside.
Keep your speakers more than 10 mm from the main unit
for ventilation.
Setup 1
Setup 2
You can put the speakers in a vertical position as well as
on a shelf.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Tweeter
█ Stacking the speakers
Stack the speakers with the
supplied speaker stacking pins.
Press down the stacking pins
and the speaker until it is
secured in position.
Stacking pin
Install the supplied bracket as shown below to
secure the speakers.
Screw
Bracket
Speaker feet
Protection layer
(not supplied)
█ Attaching the speaker feet
Before placing the speakers in a vertical position,
lay the speakers on top of a protection layer and
paste the supplied speaker feet to the bottom of the
speakers.
ENGLISH
MAX8000_6000GS.book Page 5 Tuesday, March 24, 2015 4:28 PM
offset printing