Panasonic SC-TMAX10PU

15
6.2. Self-Diagnostic Error Code Table
Self-Diagnostic Mode provides information on any problems occurring for the unit and its respective components by displaying
the error codes.
Error Code Description
Solution
F61 DAMP output abnormal. Check following:
1. Speaker wires short,
2. Speaker connection.
F76 Power supply abnormal. Check supply voltages on Main
P.C.B.
F703 Bluetooth Communication
abnormal.
Communication between module
and micro-p abnormal
Check Bluetooth P.C.B. on VFD
P.C.B. Unit.
F77 Bluetooth address error
If there is no valid Bluetooth
address in EEPROM.
Ch e ck EE PR O M I C o n Ma i n
P.C.B.
6.3. Sales Demonstration Lock Function
Item
FL Display Key Operation
Mode Name Description
Entering into Sales
Demonstration Lock
Function
To enter into the sales
demonstration lock mode.
Lock function mode will
maintain after Power ON/
OFF or AC In/Out.
The display will show upon
entering into this mode for 2 sec.
In CD mode:
Step 1: Set volume at [0].
Step 2: Press and hold [
q
] and
[SELECT] buttons on main
set for more than 2 seconds.
Note:
[
q
] button is invalid and the main
unit displays "LOCK" while the lock
function mode is entered.
To cancel the sales
demonstration lock mode.
The display will show upon
entering into this mode for 2 sec.
In CD mode:
Step 1: Set volume at [0].
Step 2: Press and hold [
q
] and
[SELECT] buttons on main
set for more than 2 seconds.
- - LOCK - -
Cancellation of Sales
Demonstration Lock
Mode
- UNLOCK -
“Cold Start” will release the
lock function mode.