Panasonic SC-ZT2 User Manual (English)

Questions and Answers:

B
bakerjosephAug 7, 2025
What to do if my Panasonic Home Theater System displays REMOTE 2 or REMOTE 1?
- E
  Erin ChapmanAug 7, 2025
  If your Panasonic Home Theater System displays 'REMOTE 2' or 'REMOTE 1', you need to set the same remote control code for both the main unit and the remote. If “REMOTE 2 ” is displayed, set the code to “2 ” on the remote control in step 4 of procedure “When other equipment (mini component system, AV amp, etc.) manufactured by Panasonic operates with the remote control operations of this system”. When “REMOTE 1 ” is displayed, set the code to “1 ” on the remote control in step 4 in the same way.
J
Jonathan CharlesAug 11, 2025
What to do if my Panasonic Home Theater System shows error code U703?
- T
  thomaslambertAug 11, 2025
  To address error code U703 on your Panasonic Home Theater System, try the following steps: - Turn the connected equipment off and on again. - Disconnect the HDMI cable, then reconnect it. - Ensure you do not connect more than 2 sets of equipment to the system’s output. If the error persists after these steps, consult your dealer.
E
Evan MyersAug 15, 2025
What to do if my Panasonic SC-ZT2 displays 'SWITCH OFF POWER (Scrolling)'?
- K
  katierodriguezAug 15, 2025
  If your Panasonic Home Theater System displays 'SWITCH OFF POWER (Scrolling)', turn off the system, unplug the AC mains lead, and consult your dealer.
K
Katie BondAug 19, 2025
What does error code U704 mean on my Panasonic SC-ZT2 Home Theater System?
- T
  Traci BowersAug 19, 2025
  If your Panasonic Home Theater System displays error code U704, check the settings of the connected equipment.
M
Melanie DeckerAug 25, 2025
Why sound field effects are not available when using headphones on Panasonic SC-ZT2?
- S
  Samantha FoleyAug 25, 2025
  You cannot use the sound field effects on your Panasonic Home Theater System when using headphones.
J
Johnny CarterAug 28, 2025
Why Dolby Virtual Speaker, SFC and Dolby Pro Logic effect do not work with my PCM source on Panasonic SC-ZT2?
- W
  William GuerreroAug 28, 2025
  You cannot use Dolby Virtual Speaker, SFC, and Dolby Pro Logic effect with PCM signals with a sampling frequency of over 48 kHz on your Panasonic Home Theater System.
M
Mario RamseySep 2, 2025
What does blinking MUTE mean on Panasonic SC-ZT2?
- C
  cdanielSep 2, 2025
  The 'MUTE (Blinking)' indication on your Panasonic Home Theater System is always displayed while muting is active.