32
LSQT1211
Setup
≥ The date and time function are driven by a
built-in lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery. When you turn on
the power for the first time after charging, a
message asking you to set the date and time
will appear. Select [YES] and set the date and
time.
To recharge the built-in lithium battery
Connect the AC adaptor or attach the battery
to the unit, and the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (Even if the OFF/
ON switch is set to OFF, the battery is still
being recharged.)
Adjusting the LCD
monitor
1
Press the MENU button, then
select [SETUP] # [LCD SET] #
[YES] and press the joystick.
2 Move the joystick up or down to
select the item to be adjusted.
Then, move the joystick left or
right to make the adjustment.
The bar display moves.
[BRIGHTNESS]:
Brightness of the LCD monitor
[COLOUR]:
Colour level of the LCD monitor
≥ When the LCD monitor is rotated by 180°
towards the lens, the brightness and colour
level of the LCD monitor cannot be adjusted.
≥ These settings will not affect the images
actually recorded.
Display style Screen display
[Y/M/D] 2007.12.15
[M/D/Y] 12.15.2007
[D/M/Y] 15.12.2007
WARNING
THE LITHIUM BATTERY IN THIS
EQUIPMENT MUST ONLY BE REPLACED
BY QUALIFIED PERSONNEL. WHEN
NECESSARY, CONTACT YOUR LOCAL
PANASONIC SUPPLIER.
Adjusting the brightness and
colour level
MENU
LSQT1211(PAL_ENG).book 32 ページ ２００７年２月１３日 火曜日 午後１時１４分
Downloaded From VideoCamera-Manual.com Manuals
To Next Page
Loading...
