RQTX0047
6
Setup
Setup
Refer also to the operating instructions for your home theater unit.
Conserving power
The wireless system consumes a small amount of power, even when it is
off (approx. 0.2 W). To save power when the unit is not to be used for a
long time, unplug it from the household AC outlet.
Making the wireless link
1
Turn on the wireless system.
2
Turn on your home theater unit and check the wireless
link indicator on the home theater unit.
3
Start play on the home theater unit.
AUTO OPERATION ON/OFF
POWER
Unit on/off button [POWER C I, B Í]
Use this button to turn the unit on and off.
C
I
: The unit is on.
B Í
: The unit is off.
AUTO OPERATION ON/OFF indicator
The indicator lights red when the unit is turned on and lights green
when the wireless link is activated.
When the wireless link is inactive for a long time, it turns red.
ONO
SLP
ST CT
RDS
RND
PGM
EQ
PRG
SRDE.
PL
DDTS
W2
WS
W1
“ [W1] ”or an indicator should light up.
≥ If “ [W1] ” or an indicator is flashing,
refer to page 7, Troubleshooting guide.
e.g. Display on the home theater unit
∫ Pairing with existing SH-FX85 (not included)
Your SE-FX65 can be used with SH-FX85, both operating on the same
wireless system as SH-FX85. By pairing, you can enjoy the benefits of
both systems working together simultaneously.
Preparation
≥
Use the SH-FX85T transmitter card for pairing.
Store your SH-FX65T transmitter card in a cool dry place for later use.
≥Make sure that the speaker and AC cord connections on page 5 are
completed.
≥Turn on the home theater unit and SH-FX85, and then reduce the
volume.
1 Turn on SE-FX65.
2 While pressing [5/9] on the home theater unit,
press the numbered button [3] on the remote control until “P” lights
in the home theater unit’s display.
≥The indicator on SE-FX65 turns green.
3 While “P” is displayed, press [I/D SET].
4 While pressing [5/9] on the home theater unit,
press the numbered button [3] on the remote control.
≥
“
[W1]
” or the wireless link indicator lights on the home theater unit.
5 Turn off and on SE-FX65.
≥Make sure the indicator on SE-FX65 lights up green.
[Note[
Repeat the above steps if you should use SH-FX65T transmitter card
(the link with SH-FX85 will be disconnected).
Use a pointed object.
RQTX_FX65_En.fm Page 6 Tuesday, December 5, 2006 2:58 PM
To Next Page
Loading...
