5
RQT6080
Button Display/referenceOperation
To pause play
To stop play
To turn off the
unit
Track skip
forward/
backward
Off mode
Stop mode
Sequential Play with MP3 files
Basic Play
Follow steps 1–6.
In step 2: Connect the stereo headphones to the [Ë] jack. (Plug in firmly.)
In step 5: The time until play starts depends on the number of files on the disc. If the unit cannot read the disc cor-
rectly (it is scratched or dirty or the unit is bumped), some files may be left unread or the disc may not be
read at all (“)” and “ERROR” appear).
≥If in Album mode, play stops after the last track in the album. If in Disc mode, play stops after the last track on the disc.
≥If the unit has been connected to the car audio system, adjust the volume level between 4 and 6 on the unit, then
adjust the volume level on the system.
≥You can only skip tracks in the current album
when in album mode.
≥During program play (page 6), these buttons are
used to skip forward or back through the pro-
grammed sequence of tracks.
≥During random play (page 6), the skip buttons
cannot be used to skip back to tracks that were
played previously in the random sequence.
Press during play.
Press during play.
Press during stop mode.
Press during play.
(Press [:] twice to skip to the
beginning of the previous track.)
Press again to restart play.
Album number
Track number
Track number in play
Elapsed playing time of each track
Label must face upward.
Plug type:
3.5 mm (1/8 in.) stereo
To switch between Album and
Disc mode
Plays all the tracks in the current album.
Plays all the tracks on the disc.
Press during play or stop mode.
The setting switches as shown below each time you
press the button.
Album mode
Disc mode
Album mode
Disc mode
Note!
≥You cannot search when playing MP3 files.
≥If the disc is scratched or the condition of the recording is poor, some noise may occur or “ERROR” may be dis-
played before the unit goes to stop mode.
Display while reading files
To confirm the album number
You can see which album the current track is in.
Press during play.
The album number is displayed for about 1 second.
Note!
You cannot do the operation above during program play
(page 6).
The unit stores data it has read so play can start
again immediately when you press [1/;]. This
stored data is lost after 10 minutes when using bat-
teries or if you replace the disc.
Counts the files
(tracks) on the disc
Close the lid.
To Next Page
Loading...
Need help?
General
