RQT7022
6
A
Set Up A
1 Place the main unit on the stand with
the unit facing up.
2 Slide the unit onto the stand, aligning
the sensor
a with the holder b.
a wireless remote control sensor
b wired remote control holder
3 “Click” is heard when it is firmly
inserted .
Placing the wired remote control B
You can clip the wired remote control onto the holder and
place the cords as shown.
Placing the Audio/Video cable and
AC adaptor cord C
Refer to Before Operating the Unit (page 14) and Power
Supply Preparations (page 10) for information on
connecting the Audio/Video cable and AC adaptor cord.
You can place the Audio/Video cable on the cable holder
c and the AC adaptor cord on the other cable holder d.
Removing the main unit from the
stand C
1. Unplug the Audio/Video cable and AC adaptor
cord from the main unit. You can leave the cables
on the cable holders c and d for the
convenience of future use.
2. Remove the wired remote control from the stand.
3. Press down the catch e to remove the main
unit from the stand.
B
Setting up the Stand
SL-MV65
C
a
b
c
d
e
a
b
Stand
Click!
>
Stand
To Next Page
Loading...
