Panasonic SL-PD347

Concerning Compact Discs
With this changer, you can only play compact
discs having this mark:
n COMPACT
(MSS
DIGITAL AUDIO
Handling precautions
•To open the compact disc case, gently press the sides of the top,
holding the top at both sides and pull up.
•To remove the disc from the case, press the center holder and lift
the disc, holding by the edges.
•Do not use record cleaning sprays, benzine, thinner, static elec¬
tricity prevention liquids, or any other solvent on discs.
•If the surface is soiled, wipe gently with a soft, damp (water only)
cloth.
•Always move the cloth directly outward from the center of the disc,
not in a circular motion as with standard phonograph records.
•If you are taking the disc from a cold to a warm environment,
moisture may form on the disc. Wipe this off with a soft, dry,
lint-free cloth before using the disc.
•Do not write on the label side with a bail-point pen or other writing
instrument.
•To return the disc to the case, insert the disc with label facing up
and press downward at the center.
•Hold compact discs by the edges so you will not soil the surface
with fingerprints. Fingerprints, dirt, and scratches can cause skip¬
ping and distortion.
Storage precautions
•Be sure to store discs in their cases to protect them from dust,
scratches, and warping.
•Do not place or store discs in the following places:
1) Locations exposed to direct sunlight.
2) Humid or dusty locations.
3) Locations directly exposed to a heat vent or heating appliance.
4) In the glove compartment or rear deck of an automobile.
Maintenance
To clean this unit, use a soft, dry cloth. If the surfaces are extremely
dirty, use a soft cloth, dipped into a soap-and-water solution or weak
detergent solution. Wring the cloth well before wiping the unit. Wipe
once again with a soft, dry cloth.
Never use alcohol, paint thinner, benzine, nor a chemically treated
cloth to clean this unit.
Such chemicals may damage the finish of your unit.
Technical
■ Audio
No. of channels
Frequency response
Output voltage
Dynamic range
S/N
Total harmonic distortion
Wow and flutter
DA converter
Output impedance
Load impedance
Specifications
2 (left and right, stereo)
2-20,000 Hz, ±1 dB
2 V (at 0 dB)
92 dB
100 dB
0.007% (1 kHz, 0 dB)
Below measurable limit
MASH (1 bit)
Approx. 1 kQ
More than 10 kQ
■ Pickup
Wavelength
■ General
Power consumption
Power supply
Dimensions (WxHxD)
Weight
780 nm
15 W
AC 50/60 Hz, 230-240 V
360x128x407 mm
4.5 kg
Note:
Specifications are subject to change without notice.
Weight and dimensions are approximate.
MASH is a trademark of NTT.
23