Panasonic SL-PD347

Troubleshooting Guide
Before requesting service for this unit, check the chart below for a possible cause of the problem you are experiencing. Some simple checks or a
minor adjustment on your part may eliminate the problem and restore proper operation.
If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the directory of
Authorized Service Centers (enclosed with this unit) to locate a convenient service center, or consult your dealer for instructions.
Problem
Probable cause(s) Suggested remedy
Changer will not play. The disc(s) or other foreign object(s) has fallen
inside of the changer.
•Open the loading drawer then remove the object.
Moisture has condensed in the changer. • Switch ON and allow the changer to dry out for
about one hour before using the changer.
The disc in the changer
does not play.
The disc is upside down. •Be sure the label is facing upward.
The disc is dirty.
•Wipe the disc with a soft cloth.
The disc is scratched.
• Replace the disc with a new disc.
The disc is warped.
The disc is not within specified standards.
A certain music passage
won’t play correctly.
The disc is dirty. •Wipe the disc with a soft cloth.
The disc is scratched.
• Replace the disc with a new one.
There is noise from the
tuner or disturbance on the
TV screen.
Caused by high-frequency signals of this changer.
•Use the changer farther away from the tuner or TV.
• If the tuner’s or TV's antenna is the indoor type, use
an outdoor one.
When program play is
started, an error message
(-E) appears on the display.
Playback was started without a track being
programmed.
• Program a track.
An error message (-E)
appears on the display, and
the changer stops
operating.
The mechanism of the changer has been
improperly adjusted.
•Turn the power switch to STANDBY and then back
ON again.
However, if the loading drawer is fully open, take
out the compact disc(s) at the front position and
then turn the power switch to STANDBY and then
back ON again.
The loading drawer stops in
the middle of opening.
About moisture
Moisture may form on the lens in the following cases...
• Immediately after a heater has been turned on.
•In a steamy or very humid room.
•When the unit is suddenly moved from a cold environment to a
warm one.
If moisture forms inside this unit, it may not work properly. In this
case, turn on the power and wait about one hour for the moisture to
evaporate.
Matsushita Electric Industrial Co., Ltd.
Central P.O. Box 288, Osaka 530-91, Japan
Printed in Japan RQT1959-L
F0393L0