Panasonic SL-S202

Other Play Methods
The letters such as © in the various illustrations refer to the descriptions in the “Location of Controls” section {see page 2).
Skip play
Program play
Repeat function
The disc plays from the specific track through to the
end, then play stops automatically.
Preparation: Put unit in stop mode.
1
< NORMAL")
^ RESUME I I I RANDOM
® mnTTon
2 Select the desired track.
*S*1P * SEMCT
Random play
1
0
NORMAL
RESUME I I l RANDOM'
r~rnnm
I Releasel
0
< NORMAL)
RESUME I I I RANDOM
nwrnm
For your reference:
•It is also possible to press the button white the
unit is in stop status to change the first track to be
played. (All tracks are played eventually, regardless of
which is played first.)
•Program play is not possible in the random mode.
Resume play
This function allows you to listen from the beginning of
the track where play stopped because the unit was
powered off (or switched to stop status). It is useful
when listening to CDs in the car. etc.
_ NORMAL
^ RESUME I I I RANDOM
0 i D 0 I Bin
1 Release]
< NORMAL)
A RESUME I I I RANDOM
® flop I oon
Up to 24 tracks can be entered in the programmed se¬
quence.
Preparation:
1
Put unit in stop mode.
< NORMAL")
4^ RESUME I I I RANDOM
W nun.I o°n
2 Select the desired track.
♦ SKIP - SEARCH
3
Register in sequence.
(The indication “M“ and the programmed se¬
quence appear on the display panel.)
0
MEMORY/
4 Repeat steps 2 and 3 to program all
the desired tracks.
5
■ To program the same track in the se¬
quence more than once
After step 3, press MEMORY/RECALL the desired
number of times.
Press REPEAT while disc is playing or when unit is in
stop status.
REPEAT
For your reference:
If REPEAT is pressed during program play, only the
tracks in the program are repeated.
(The indication “ALL” is not displayed.)
The setting is switched in the sequence indicated below
each time REPEAT is pressed.
1-track repeat (1 O)*-
One track is repeated.
All-track repeat (ALL CJ)
All the tracks on the disc are repeated.
Cancel-
Changing the sound quality
XBS ON:
Select this setting to boost the low-range response.
XBS
ONI lOFF
THTn
® (o
OFF:
Select this setting to turn off the XBS function.
XBS
^ ONI I OFF.'
O non I o o 1
■ If u P ” is displayed
No more tracks can be programmed.
■ To confirm the contents of the program
Press MEMORY/RECALL while the disc is playing.
(The number of the programmed tracks appear on
the display panel in sequence.)
I3HE1
This function is not available when using the OUT jack.
■ To delete the entire programmed se¬
quence
Press ■ , POWER OFF.
For your reference:
• If the RESUME, NORMAL, RANDOM (play mode)
slider is put in the RESUME position, the all¬
repeat function will be activated automatically as soon
as the unit is powered on.
•If power is cut off near the end of a track (power off
status), playback may resume from the beginning of
the next track.
• If the unit is powered off while a disc was playing and
then a new disc is inserted, play will begin from the
middle of the new disc because the unit remembers
the position where play stopped on the old disc.