Panasonic SL-S202

Anti-Shock Function
This function minimizes sound interruption when vibra¬
tions are encountered by utilizing audio data that has
been stored ahead of time (up to approximately 3 sec¬
onds worth).
1
ANTI-SHOCK
OKI I OFF
© 10 0 I Don
M.RESERVE
indicator status
Unit body status
Play status
(audio data status)
_D
Stable Normal (plenty of data is stored)
in*)
Bump encountered Normal (stored data is used)
Bumping stops
Normal (data again starts to be stored)
^ » 1
Bumps continue repeatedly Sound is interrupted (data buffer empty)
Notes
•The position of the ANTI-SHOCK slider can be changed during
play, but this may cause a slight interruption in the sound be¬
cause the disc's rotation speed changes.
• During anti-shock operation, the disc rotates at a higher rate
than usual in order to collect extra audio data. This may cause
the batteries to run out faster and could result in a slight in¬
crease in disc rotation noise.
Using the unit with an audio system
The anti-shock uses digital signal compression technol¬
ogy. It is recommended that the ANTI-SHOCK be kept
in the OFF position if the unit is connected to a home ,
audio system.
Using the Unit with Optional Accessories
Using the unit with an audio
system
Using stereo connection cable (not included), you can
hear CDs on your audio system.
•Connect the cable to the amplifier after turning off its
power.
•Do not connect the cable to the PHONO jacks on the
amplifier.
•Obtain the optional connecting cable if the amplifier
comes with mini-phone jacks.
•Adjust the volume on the amplifier.
OUT jack
Stereo connection cable (not included).
Using the unit with a car audio
system stereo
Items to be purchased
For connection to the car audio system:
Car stereo cassette adaptor (SH-CDM10A)
Connect the car stereo cassette adaptor |
| to the unit’s headphones jack.
! (When doing this, keep the unit’s VOLUME |
| control at a setting between 4 and 6.)
For securing the unit and connecting the
power supply:
• Car adaptor (SH-CDC9)
• Car mounting kit (SH-CDF7)
Car mounting arm. Car insulator
II may not be possible to use me unit with some types of car
stereos owing to restrictions imposed by the construction o( the
car stereo cassette adaptor.
For further details, refer to the instructions of the part concerned.
5
RQT4990