15
In trouble
Error Codes Indication
Error display
Ref. page
● Has the pan being set?
→ Press the [O/Cancel] key until the error display disappears. Put
the dedicated pan in, and perform the operation Again.
(If you don't press the [O/Cancel] key, the error display will
disappear automatically after a moment.)
—
● Try to unplug the power plug and plug it in again.
If "H※※" still appears, then there is a fault.
→ Please consult the Panasonic authorized service center, and
inform the error code (two digits after "H").
—
● Keep warm duration over 96 hours?
→ Please press [O/Cancel] key.
8
● Is any foreign object attached to the bottom of the pan or the
bottom sensor?
→ Please remove foreign objects and dirt, and then press the
[O/Cancel] key.
● Is water too much?
→ Press the [O/Cancel] key.
(For continuous cooking, you can slightly reduce the amount of
water)
4
7
● Has any dust or other foreign object clogged the intake port and
the exhaust port at the bottom of the rice cooker?
→ Remove dust according to the following steps.
①
Press the [O/Cancel] key, and then unplug the power plug.
②
Remove the pan until the rice cooker cools down.
③
Clear the dust in the intake port/exhaust port at the bottom
of the rice cooker. ( P10)
● Is the rice cooker used on the carpet?
→ Do not use the rice cooker where the bottom of the rice cooker
may be clogged.
—
4
Please check before requesting a repair.
If the rice cooker is still not back to normal after the above is conrmed, go to the Panasonic authorized service center for
repair.
Please check
To Next Page
Loading...
