Cleaning the stainless steel part (metal part of the Inner Lid)
若上述的清潔劑無法去除內蓋不鏽鋼部分的污垢，請使用不會刮傷不鏽鋼的非磨蝕性清潔劑，以抹布
或海棉來進行擦拭。
不鏽鋼部分（蓋加熱板的金屬部分）的保養方法
1
2
Wipe with a well-wrung cloth.
請用擰乾的抹布擦拭
乾淨。
• Do not pour water inside to clean.
●請勿將水倒在裡面。
2
2
3
After removing the Taste Catcher, wipe with a well-wrung damp cloth.
Also wipe seal with a well-wrung damp cloth.
Inner Pan ( P.7)
Place attaching
the Taste Catcher /
Inside of outer Lid
Convex point of
the Taste Catcher
Cleaning清洗
Cleaning
清洗
以稀釋後的洗碗精 (中性) 和海棉來清洗，然後再擦乾水份。
Wash with diluted dish soap (neutral) and a soft sponge,
and then wipe the moisture off.
Important Information敬請注意
●
在剛煮好飯後，本體溫度變高。 要進行清潔保養時，請務必拔下電源插頭待本體冷卻後再進行。
●請勿使用苯、稀釋劑、酒精、清潔劑、金屬刷或尼龍墊 (刷)來進行清洗。
●請勿使用洗碗烘乾機或食具烘乾機進行烘乾。
Upper Frame上 緣
Important Information
敬請注意
To clean the Pan Sensor, use diluted dish soap
(neutral) and scrub with nylon pads (brush) lightly.
若要清潔內鍋感應器，請使用稀釋後的洗碗精
(中性)，並以尼龍墊 (刷) 輕輕擦洗。
Pan Sensor
內鍋感應器
Inner Lid
蓋加熱板
Wipe with a well-wrung damp cloth.
請用擰乾的抹布擦拭乾淨。
■Removing the Inner Lid
■安裝方法
■
Attaching the Inner Lid
■拆卸方法
將位於內蓋底部的凸耳朝你的方向拉。
將位於內蓋上方的突起部插入外蓋上方的洞中。
Insert the fixture located on the top part of the Inner Lid into the holes
at the top of the Outer Lid.
Push the Inner Lid knobs (located on both sides) in until you
hear a clicking sound.
將凸耳 (位於內蓋的左右兩邊) 往內推，直到你聽到喀嚓聲。
Important Information /
敬請注意
●Please wash the Inner Lid immediately after cooking if seasoning was used (after cooking mixed rice
or congee, etc). Otherwise foul odour, corruption, or rust may develop.
●
Remove all the excess water from the Inner Lid and Seal before attaching.
●若有使用調味料進行炊煮 (如什錦飯或粥等)，請於炊煮完畢後，立即清洗內蓋。
否則，可能會產生氣味，甚至可能會發生分解腐爛和生霉情況。
●將蓋加熱板和密封墊充分擦乾後再裝到本體上。
Fixture
Top part of the Inner Lid
Seal
Inner Lid knobs
突起部
「 」（上）標記
密封墊
凸耳
Taste Catcher美味感應裝置
Place attaching the Taste
Catcher • Inside of Outer Lid
Main Body and
Outer Lid
本體、外蓋
密封墊（不要取下）
Seal (Do not remove)
Lift it up.
往上抬起。
Match the positions of
▼
and
▲
.
使▼和▲記號的位置對準。
Turn it in the direction of the arrow
until you hear a clicking sound.
朝箭頭方向旋轉直至聽到「喀嗒」一聲。
Set the Taste Catcher on the Outer
Lid as seen as on the picture and
push it in the Outer Lid.
(
Make sure that there is no gap between
the Taste Catcher and the Outer Lid.)
依圖片所示將美味感應裝置放在
外蓋上的指定位置，然後再將它
推進外蓋中。 （不得浮起或傾斜）
Turn it in the direction
of the arrow and pull it.
朝箭頭方向轉動並往前拉出。
Removing the Taste Catcher /
美味感應裝置拆卸方法
Attaching the Taste Catcher /
美味感應裝置安裝方法
Important Information敬請注意
●
如果美味感應裝置內污穢或有異物，則可能會引起誤動作。 請把它在水中清洗乾淨。
將美味感應裝置卸下後，請用擰乾的抹布擦拭乾淨。 同時也請以擰乾的濕布擦拭密封墊。
●
The Warm Jar may be still hot soon after cooking. Unplug it and wait for it to cool down before beginning to clean it.
●Do not clean with benzine, thinner, alcohol, cleanser, metal scrubber, or nylon pads (brush).
●Please do not use dishwasher.
●Foreign objects that may remain in the Taste Catcher could
cause malfunctions. Please keep the area clean.
飯勺
Rice Scoop
Wash after
every use
每次使用後均需清洗
粥勺
Ladle
內鍋
Inner Pan
蓋加熱板
Inner Lid
美味感應裝置
Taste Catcher
蒸籠
Steaming Basket
Pull the Inner Lid knobs located on the bottom
part of the Inner Lid towards you.
If it is not possible to clean the stainless steel part of the Inner Lid with detergents mentioned above,
use a non abrasive cleanser that does not scratch stainless steel, and wipe it off with a cloth or a
sponge.
●
Wash before using for the first time also.
●初次使用時也請先洗一下。
• If the Pan Sensor is not clean, the quality of
cooking may not be satisfactory. It may cause
over cooked rice or display error.
●如果沒有將內鍋感應器擦洗乾淨，可能會導致
炊煮的品質不佳。 也可能會造成米飯煮得太爛
或顯示錯誤訊息。
Note
須 知
內鍋 （第7頁）
將附帶的美味感應裝置
放入 /
外蓋的內部
美味感應裝置
的
凸起點
將附帶的美味感應裝置放入·外蓋的內部
To Next Page
Loading...
