Do you have a question about the Panasonic SV-3700 and is the answer not in the manual?
Functionality and settings of rear panel DIP switches.
Controls for tape indexing (Start/Skip ID, End) and search functions.
Recommended periodic maintenance schedule and purpose.
Table detailing part replacement and cleaning intervals.
Step-by-step guide for cleaning heads and transport.
Steps for removing the upper cylinder (head assembly).
Steps for removing loading unit, main, servo, and RF PCBs.
Steps for removing the cabinet and front panel.
Diagrams of adjustment points and list of necessary tools.
Initial steps including cabinet removal and loading unit prep.
Adjusting ATF gain using oscilloscope and VR107.
Adjusting RF recording level using oscilloscope and VR104/VR105.
Adjusting PLL free run frequency with a frequency counter.
Adjusting PG phase using oscilloscope and VR201.
Verifying and adjusting BOT/EOT detection sensitivity with VR271.
Critical warning for linearity adjustment using post rollers.
Adjusting DAC output balance with VR501/VR502.
Adjusting DAC offset with VR503/VR504.
Pinout and functions for the RF amplifier IC.
Pinout and functions for the servo processor IC.
Pinout and functions for the ATF IC.
Pinout and functions for the linear servo IC.
Pinout and functions for the playback PLL IC.
Pinout and functions for the A/D converter IC.
Pinout and functions for the system control IC.
Pinout and functions for the mechanism control IC.
Pinout and functions for the serial/parallel converter IC.
Pinout and functions for the D/A converter ICs.
Pinout and functions for the digital signal processor IC.
Pinout and functions for panel control and FL drive IC.
High-level block diagram of the entire system.
Detailed block diagrams for servo and motor circuits.
Detailed block diagrams for servo and control circuits.
Terminal functions for ICs, transistors, and diodes.
Terminal functions for ICs, transistors, and diodes.
Diagram showing connections between major PCBs and blocks.
Key points for mechanism, capstan, cylinder, and ATF troubleshooting.
Key points for signal processing, panel, head, and analog troubleshooting.