Panasonic SV-3800 - Recorder Playback Features; Skipping Programs (Skip Play); Music Scan for Segment Identification

E-14
Skipping Programs (Skip Play)
Playback Functions provided by the Recorder
This function cues to the next tape position where a Start ID has been recorded.
Notes: * This function may not operate correctly in the case of very short audio segments (about 30 sec. or less).
¢ This function is different from Auto Skip Play Function in indexing. (Refer to pages E-23 and E-26.)
Skip forward or backward (Forward or Reverse Skip Play)
Note:
Note:
(1) Setting the skip number
In the playback, standby or stop mode, press the forward or reverse SKIP button.
When the button is pressed, the skip number is incremented or decremented by 1; when it is kept depressed more
than 1 sec., the number is continuously incremented or decremented (up to +99).
Press the forward or reverse SKIP button so that the number of programs you want to skip are displayed in the
program number display panel. The number of times the button is pressed is indicated with a plus “+” or a minus
“on si gn.
During reverse skip, the segment now being played is counted as one skip.
(2) Starting skip search
Skip search is started after the skip number setting is entered.
Action taken Operation
1) Donot press the SKIP button within 2 seconds after Search is commenced automatically.
the skip number was set. (In the playback mode, playback is started after the
search, and in the other mode, the pause mode is
established after the search.)
2) Press the PLAY or PAUSE button within 2 seconds Playback search or pause search is commenced.
after the skip number was set.
The PLAY or PAUSE button may by be pressed even during search operation to select either mode upon
completion of the search.
During skip search, changing the skip number is not possible.
Skip during program play
Each time the SKIP button is pressed during program play, the program sequence changes and is displayed.
After the program sequence has been memorized and the forward SKIP button is pressed while a certain
selection is being played, the tape advances to the next selection.
After the program sequence has been memorized and the reverse SKIP button is pressed while a certain selection
is being played, the tape goes back to the beginning of the current selection. If the button is pressed again, the
tape goes back to the beginning of the previous selection.
Identifying the Contents of Each Program Recorded on the Tape (Music Scan Play)
Note:
Press MUSIC SCAN button.
The beginning of each audio segment from which MUSIC SCAN button is pressed will be played for approx.
15 sec., and the play indicator will flash. .
If a desired audio segment is found during scanning, press the PLAY button to continue playback. When the unit
is changed to the playback mode, the play indicator will illuminate.
To interrupt the scan, press the STOP button.
Music scan does not function during program play.