Panasonic SV-3800

System Display Mode Selection
System Display Mode }
The SV-3800 has several operating parameters that can be accessed by the front panel display. In system display
mode, these parameters may be checked or altered. The values set in this mode are retained when the power is
turned off.
(1) Entering the system display mode
Press the COUNTER MODE + COUNTER RESET + PAUSE buttons (=DISPLAY FUNCTION SELECTORS)
simultaneously.
Recorder is set to the digital input/output terminal selection mode (mode No.0) of system display mode.
“Q-” appears on the program number display.
(2) Selecting the display mode
Press the COUNTER MODE button.
Each time the button is pressed, the display mode changes in the order of the mode number.
The mode No. of the selected display mode is displayed.
(3) Returning to the regular display (releasing the system display mode)
Press the COUNTER RESET button.
Selecting the system display mode:
Mode No. 0 = Digital input/output Mode No. 1 = Digital output
[Original display] terminals setting mode format setting mode
Indicates"IEC aN Display returns
TER coaxial terminals
cou to original display.
MODE RESET COUNTER COUNTER
O Ores selected. MODE RESET
DISPLAY FUNCTION SELECTORS: a
Select the Release the system
oF display mode. display mode.
PAUSE
STANDBY/REHEARSAL
Indicates format for Indicates format for
Press the three consumer applications commercial applications
buttons simultaneously. taken by coaxial taken by XLR-3 terminals.
and optical terminals.
Mode Displays and Their Setting Methods
Selecting the digital input/output terminals (mode No.0)
What is displayed Actual display Significance
The currently selected terminals appear on the 1) IEC-C “Coaxial terminals” selected.
counter display.
2) TEC-O “Optical terminals” selected.
3) AES “XLR-3 terminals” selected.
To change the setting:
Press the SKIP button (forward). The display changes in the sequence of 1) through 3) above, thus changing the
terminals selected. The setting established after initialization is “TEC-C”.
Notes: When “IEC-C” or “IEC-0” has been selected, the digital output signals are supplied from both the coaxial
and optical terminals. When “AES” has been selected, the se cia output signals are supplied from the XLR-3
terminals only.
E-28