Panasonic SV-3800 - Playback Mode Settings; Program Playback Blank Skip

Note:
Note:
System Display Mode Selection
Single play mode does not take effect during Program Play, such as when programming a random sequence
of selections using the program number and MEMORY buttons on the remote control.
When a Skip ID recorded is detected during playback:
Sequence Operating mode When the single play mode is off | When the single play mode is on
of priority (normal)
1 *Sub code editing Playback continues. Playback continues.
mode
2 Skip play cancel Playback continues. PAUSE mode is established.
mode
3 Skip play mode The tape advances to the next Start +The tape advances to the next Start ID
ID and playback mode is estab- and pause mode is established.
lished.
When a Start ID recorded is detected during playback:
Sequence Operating mode When the single play mode is off | When the single play mode is on
of priority (normal)
1 *Sub code editing Playback continues. Playback continues.
mode
2 Other mode Playback continues. PAUSE mode is established.
Cancel mode
* Sub-code editing mode: refers to when the Start ID or Skip ID indicator is flashing after either of those buttons
has been pressed.
To change the setting:
Press the SKIP button (forward). The mode is switched alternately between on and off. The setting established
after initialization is “OFF”.
Any ID recorded is ignored if it is detected during the first two seconds after playback starts.
Selecting the program playback blank skip mode (mode No.4)
Note:
E-30
Program playback blank skip determines which way the SV-3800 recognizes the end of a program. This is
necessary for program play since the machine must skip to a selection at another location on the tape when the
currently playing program ends.
When blank skip mode is on, the machine skips to the next programmed selection as soon as it encounters
audio level below selected detection level for 2 seconds or more. When blank skip mode is off, the machine
skips to the next programmed selection as soon as it encounters the next Start ID or Skip ID following the
present program.
What is displayed Actual display Significance
The present program playback blank skip mode 1) PS-00 The program playback blank skip’
setting appears on the counter display. mode has been set to on.
2) PS--- The program playback blank skip
mode has been set to off.
To change the setting:
Press the SKIP button (forward). The mode is switched alternately between on and off. The setting established
after initialization is “ON”.
If the Start ID recorded is detected at the beginning of a blank section, the blank is not skipped until the
playback of the recorded section is completed.