Panasonic SV-3800

COUNTER
MODE RESET
ee Si rows
DISPLAY FUNCTION SELECTORS
cts
PAUSE
Press the COUNTER
MODE + COUNTER
RESET + PAUSE
buttons simultaneously.
Quick Reference for System Display Mode Selection SV-3800
COUNTER
MODE
Press the COUNTER
MODE button.
0 Selecting the digital TEC-C
input/output
terminals
ee
1
Selecting
the
digital
I
output
mode
se
Al
AA
2 Selecting the errorrate A and B/
displa “XxX”
ad A/“Xxxx”
B 1 OXXxx”
3 Selecting the single sp---
play mode SP-00
‘4 Selecting the program
playback blank skip PS -00
mode PS__-
5 Selecting the main ID6 00
displ i isplay i
6 Setting the nominal A04
output level A-10
7 Hour meter “XXXXX”
8 Displaying the error B® xx" xx
codes, etc.
uw
(For diagnostic purposes “XXX”
by qualified service
personnel)
9 Peak level
“t 14
A “-xx
B ax”
‘D Clemsa
DISPLAY FUNCTION SELECTORS
SKIP
COUNTER
PAUSE RESET
pg
Press the SKIP button Press the COUNTER Press the COUNTER
MODE + COUNTER
(forward). RESET + PAUSE buttons RESET button.
simultaneously, and then
release only the PAUSE
button and press the
STOP buiton.
“Coaxial terminals” selected.
“Optical terminal” selected. @ TEC-C O
“XLR-3” terminals” selected.
Format for consumer applications
taken by coaxial and optical terminals.
Format for commercial applications
taken by coaxial and optical terminals.
Format for consumer pep uealione @ Tl AA O
taken by XLR-3 terminals.
Format for commercial applications
taken by XLR-3 terminals.
The total error rate for data played
back by head A and head B max. 9984. _ = _
The error rate for data played back by
head A max. 4992.
The error rate for data played back by
head B max. 4992. a= = =
The single play mode has been set to off. ee
The single play mode has been set to on. d at O
The program playback blank skip
mode has been set to on. 7
The program playback blank skip © PS -00 O
mode has been set to off.
ID6 value set to 00: Copy-free. (User-Selectable bits at the first
ID6 value set to 11: Copy-restricted two digits only)
ID6 value set to 10: Copy-prohibited e 00 O
+4 to -6 dBu (Press FF button)
-10 dBu (Press REW button) @ A04 O
(+4 dBu)
The total head cylinder rotation time is
indicated in 5 digits (hours). _ _ O
“E” denotes that this is the error code
display mode.
Microcomputer operation mode
Not available to users — na —
The microcomputer software version
of the system controller.
Lch peak level
Rch peak level
This page can be cut out for your convenience. After cutting it out, keep it close at hand. E-35