Panasonic SV-AV10 - Recording Still Pictures; Display in Still Picture Mode

16
PICTURE
R 15
N
Recording Still Pictures
Records still pictures.
1
Set the Operation Mode to [REC>>PICTURE]
1
2
Select the [RECORDING SETUP]
2
.
3
Set the [PICTURE QUALITY]
3
to desired picture quality.
≥Select one of [FINE], [NORMAL], or [ECONOMY].
4
To use the flash, Set the [FLASH] on the [RECORDING
SETUP]
4
Menu to [ON].
≥In a dark place, will be displayed and the Flash will be
available. (The display disappears when in a bright place.)
5
Press the [MENU] Button twice to exit menu.
6
Press the Recording Start/Stop Button.
≥The still image is recorded on the Card.
ª Display in the Still picture mode
: Still picture mode
R 0000: Number of remaining recordable pictures
F/N/E: Select a picture quality. ( [F]: Fine, [N]: Normal and [E]:
Economy)
≥The image size is 640 x 480 (VGA).
≥If [NORMAL] or [ECONOMY] is selected for recording, mosaic-pattern
noise may appear on a playback image depending on the image
content.
≥The available range of the Flash is approximately 2-3.5 ft (60 to
100 cm) in a dark place.
≥Record the subject approx.
1.7 ft (50 cm)
away from it.
≥If the number of remaining recordable pictures is 10,000 or more, the
indication will be “9999”.
≥ flashes immediately after the Flash is used to indicate that pictures
cannot be recorded. Wait until it stops flashing.
≥The following table shows still image storage capacity for each image
quality settings:
The numbers shown in the above table are approximate and may vary
depending on picture content.
Fine Normal Economy
8MB 45 95 190
16MB 100 200 400
32MB 220 440 880
64MB 440 880 1760
VOL
+
-
/
MENU
MODE/
VOL
MPEG4
PICTURE
VOICE
RECPLAY
PUSH/SET
SELECT
PICTURE RECORD
PRESS MENU TO EXIT
RECORDING SETUP
OTHER FUNCTIONS
RECORDING SETUP
PRESS MENU TO RETURN
FLASH OFF ON
PICTURE QUALITY
FINE NORMAL ECONOMY
RECORDING SETUP
PRESS MENU TO RETURN
FLASH OFF ON
PICTURE QUALITY
FINE NORMAL ECONOMY
2,5
2
3
4
1
1
1,2,3,4
6
SDV1U.book16ページ２００２年２月１５日 金曜日 午後９時４４分