Check that the network settings are as shown below, and then start "Connection test".
_1_Select "Connection test" and press OK.
_Press OK again to cancel the test.
(It takes a while to cancel the test.)
-- (l_select
@ok
Succeeded:"Connection test" succeeded
Only home network:
Home network is available.
Failed: Check the broadband environment connection
and settings and the network settings, and then
perform the test again.
Test in progress
---: Test not yet performed
_ Select "IP setting mode" and set to "Automatic". • Manual setting
(When IP automatic acquisition in DHCP can be used) _i_Select "IP setting mode" and set to "Manual"
The acq ;played.
O)select
_2_ok
Each IP address is acquired automatically.
_ Select the item and press OK
_3_Check the specifications of the broadband router and
enter each IP address.
Select "DNS setting mode" and set to "Automatic". • Manual setting
(When DNS automatic acquisition in DHCP can be used) _i_ Select "DNS setting mode" and set to "Manual"
The acquired address is displayed.
@ Each IP address is acquired automatically,
If you are using a broadband router, IP automatic
acquisition in DHCP can be used under normal
circumstances. If you are not sure, check with the
person who installed the equipment, or check the
instructions for each device.
_2_Select the item and press OK
_3) Enter each IP address as was specified by the
provider.
_or
d) Select "LAN speed setting" (Default is "Automatic") ® Normally, select "Automatic".
® If "Connection test" failed, set the "LAN speed setting"
to "manual" and then select "10BASE half duplex",
"10BASE duplex", "100BASE half duplex" or "100 BASE
duplex".
® Cannot be selected when the "LAN speed setting" is
"Automatic".
® Changing the settings may make it impossible to
connect some types of equipment.
Select "Software update" Press OK to start the software update screen.
_3_Follow directions of the screen.
Set "Clock" first. (p. 18)
@
Z
d)
o
O0
d)
_3
® The network settings become effective when you close the menu and run "Connection test".
45