D._Oll il oil ii [;_ i ill I_ _lO_o) il i[_[_q [o] i
@Computer signals which can be inputare those with a horizontal scanning frequencyof 15 to 110 kHzand vertical scanningfrequency
of 48 to 120 Hz, (However, the imagewill not bedisplayed properly if the signals exceed 1200 lines,)
@Some PC models cannot be connected to the set.
@There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal,
@The maximum resolution: 1,280 x 1,024
Ifthe display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
@Signal Names for D-sub 15P Connector
Pin Layoutfor PC Input Terminal
Siqnal Name Siqnal Name Siqnal Name
f.l_ R @ GND (Ground) @ NC (not connected)
_) G ,.._,(7_ GND (Ground) @ NC
_3_ B _8_ GND (Ground) @ HD/SYNC
@ NC (not connected) @ NC (not connected) _ VD
GND (Ground) GND (Ground) NC
Care and Cleaning
First, unplug the Power cord plug from the wall outlet.
The front of the display panel has been specially treated, Wipe the panel surface gently using only a cleaning cloth or a soft, lint-
free cloth.
@ Ifthe surface is particularly dirty, soak a soft, lint-free cloth in diluted mild liquid dish soap (1 part mild liquid dish soap diluted
by 100 times the amount of water) and then wring the cloth to remove excess liquid. Use this cloth to wipe the surface of the
display panel, then wipe it evenly with a dry cloth of the same type until the surface is dry.
@ Do not scratch or hit the surface of the panel with fingernails or other hard objects. Furthermore, avoid contact with volatile
substances such as insect sprays, solvents, and thinner; otherwise, the quality of the surface may be adversely affected.
_11_
Ifthe cabinet becomes dirty, wipe it with a soft, dry cloth.
@ Ifthe cabinet is particularly dirty, soak the cloth in a weak mild liquid dish soap and then wring the cloth dry.
Use this cloth to wipe the cabinet and then wipe it dry with a dry cloth.
@ Do not allow any mild liquid dish soap to come into direct contact with the surface of the Plasma TV.
Ifwater droplets get inside the unit, operating problems may result.
@Avoid contact with volatile substances such as insect sprays, solvents, and thinner; otherwise, the quality of the cabinet surface
may be adversely affected or the coating may peel off. Furthermore, do not leave it for long periods in contact with articles made
from rubber or PVC.
@ Cleaning
Wipe the surfaces with a soft, dry cloth. If the unit is particularly dirty, clean it using a cloth soaked with water to
which a small amount of mild liquid dish soap has been added and then wipe with a dry cloth.
Do not use products such as solvents, thinner, or household wax for cleaning, as they can damage the surface
coating. (If using a chemically-treated cloth, follow the instructions supplied with the cloth.)
@ Do not attach sticky tape or labels, as they can make the surface of the pedestal dirty. Do not allow long-term
contact with rubber, vinyl products, or the like. (Doing so will cause deterioration.)
@
_'rp
o '_
'_G:3
61
To Next Page
Loading...
