Slide #62
12 Blinks Error Code Flowchart
Unplug the TV and disconnect connectors A11 and
A12 from the A board (See picture on the left). Plug
in the TV and press the power switch
Does the
TV power
up and
stay on?
No
Yes
If the speakers wires
are not pinched,
Replace
the speaker
Replace
the A board
Trouble Mode
Audio SOS
Defective Board (Possibility)
A Board, Pinched speaker wire, Speaker
Warning: Disconnect AC Power prior to making any
disconnection or connection
Start Here
If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.
To Next Page
Loading...
