Panasonic TC-P50G10

Slide #34
2 Blinks Error Code (All Models)
No
Yes
Reconnect P25 and measure the
resistance between pin 1 of
connector P6 and ground (Chassis)
Is there a
short
circuit?
Unplug the TV and check the resistance between pin 1 of connector P6 and ground (Chassis)
Is there a
short
circuit?
YesNo
Plug in the TV and turn it on. Measure
the voltage at pin 1 of connector P6
Is there
15V
present?
No
Yes
Replace
The P board
Replace
The A board
Unplug connectors P6, P11, and P25 on the P
board. Measure the resistance between pin 1 of
connector P6 and ground (Chassis)
Is there a
short
circuit?
No
Yes
Replace
The P board
Reconnect P11 and measure the
resistance between pin 1 of
connector P6 and ground (Chassis)
Is there a
short
circuit?
No
Yes
Replace
The SS board
Disconnect SC20 on the SC board
and measure the resistance between
pin 1 of connector P6 and ground
(Chassis
Replace
The A board
Is there a
short
circuit?
No
Yes
Replace
The A board
Replace
The SC board
If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.
Start Here