Panasonic TC-P50G10

Slide #54
8 Blinks Error Code (Full-HD Models)
Trouble Mode
Driver SOS3/SS_FPC_Detect
Defective Board
SS, A, SS2, P, and Loose connections
Warning: Disconnect AC Power prior
to making any disconnection or
connection.
46” Full HD Models (TC-P46S1 - TC-P46G10 - TC-P46U1). Make sure that
connectors SS61, SS63, SS64, and SS21 on the SS board and connectors SS24, and
SS58 on the SS2 board are properly seated.
42” Full HD Models (TC-P42S1 - TC-P42G10 – TC-P42U1 – TC-42PS14). Make sure
that connectors SS61, SS64, and SS21 on the SS board and connectors SS24, and
SS58 on the SS2 board are properly seated.
50” and 54” Full HD Models (TC-P50S1 – TC-P50G10 – TC-P50U1 – TC-P50V10 –
TC-50PS14 – TC-P54S1 – TC-54G10). Make sure that connectors SS53, SS55, SS56,
and SS21 on the SS board and connectors SS24, and SS58 on the SS2 board are
properly seated.
42” FHD
46” FHD
50” & 54”
FHD
Note: D280 (D16280 on the Service
Manual) is located less than inch away
from the right side of connector SS33
D280
CATHODE
ANODE
(D16280)
If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.