Slide #38
5 Blinks Error Code (All Models)
Trouble Mode
5V SOS
Defective Board
P, C, A,SC, SS board or Panel
Disconnect the TV. Measure the resistance
between pin 1 of connector P35 on the P
board and ground (Chassis).
Yes
Proceed to more extensive troubleshooting
of the slides that follow.
No
Is there a
short to
ground?
Panel
Note: Even though it
does not happen often,
the 5 blinks shutdown
can also be caused by
one of the C boards
Warning: Disconnect AC Power prior to
making any disconnection or connection.
Does the power
supply
makes a “chirp”
noise at plug in?
Start Here
Yes
No
Yes
No
Is there a
short to
ground?
Replace
the SS board
Replace
the SC board
Disconnect the TV. Disconnect
P2 and P11 on the P board
Measure the resistance between
pin 1 of connector SS11 on the
SS board and ground (Chassis).
Yes
No
Is there a
short to
ground?
All other 2009 Models
TC-P42G10 TC-P46G10 TC-50G10 TC-P54G10
Measure the resistance between
pin 1 of connector SC2 on the SC
board and ground (Chassis).
Replace
the P board
Start Here
If the power LED continues to blink even after the TV is unplugged, press and hold the power
switch on the TV for a few seconds until the LED turns off.
To Next Page
Loading...
