20
9.2.7. Remove the PSS-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the hooks and the tapes to free the cables
2. Disconnect the connectors (P2 and P35).
3. Disconnect the bridge connector (A6A-P6).
4. Disconnect the flexible cables (SS52 and SS55).
5. Remove the screws (×7 , ×1 ,×1 ) and remove
the PSS-Board.
9.2.8. Remove the A-Board
1. Unlock the hooks and the tapes to free the cables.
2. Disconnect the connectors (A1 and A12).
3. Disconnect the bridge connector (A6A-P6).
4. Disconnect the USB cable (JK8605).
5. Disconnect the flexible cables (A20, A31 and A32).
6. Remove the screws (×4 ).
7. Remove the Side shield metal.
8. Remove the A-Board.
9. Remove the screws (×4 ) and remove the A-Board
mount metals.
9.2.9. Remove the Speakers
1. Unlock the hooks and the tapes to free the cables.
2. Disconnect the Speaker terminal.
3. Remove the screws (×2 each) and remove the Speak-
ers (L, R).
9.2.10. Remove the SU-Board
1. Disconnect the flexible cables (SU1, SU2, SU3, SU4 and
SU5) connected to the SU-Board.
2. Disconnect the flexible cable (SU11-SD11) and the bridge
connector (SC41-SU41).
3. Remove the screws (×2 , ×1 ) and remove the SU-
Board.
To Next Page
Loading...
