22
9.2.16. Remove the K-Board
1. Remove the screws (×2 ) and remove the LED panel
case.
2. Disconnect the connector (K10).
3. Remove the claw (×1 ) and remove the K-Board.
4. Remove the LED panel.
9.2.17. Remove the Cabinet assy from the
Plasma panel section
1. Place the Cabinet assy on a flat surface of a table (cov-
ered by a soft cloth) and a cushion.
2. Remove the screws (×17 ).
3. Remove the Cabinet assy from the Plasma panel section.
9.2.18. Remove the Contact metals
1. Remove the screws (×16 ).
2. Remove the Contact metal side (L, R).
3. Remove the screws (×15 ).
4. Remove the Contact metal bottom.
9.2.19. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
2. Disconnect the flexible cable (C10).
3. Disconnect the connector (C18).
4. Remove the screws (×4 ) and remove the C1-Board.
To Next Page
Loading...
