23
9 Disassembly and Assembly Instructions
9.1. Remove the Rear cover
1. See PCB Layout (Section 3)
9.2. Remove the AC inlet
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable.
2. Disconnect the connector (P9).
3. Remove the screws (×2 ) and remove the AC inlet.
9.3. Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable
2. Disconnect the connectors (P2, P6, P9, P11 and P35).
3. Disconnect a short-jumper connector P34 and re-use for
new P-Board.
4. Remove the screws (×7 ) and remove the P-Board.
9.4. Remove the Side terminal
cover
1. Remove the screws (×2 ).
2. Remove the Side terminal cover.
9.5. Remove the Tuner unit
1. Remove the Side terminal cover. (See section 9.4.)
2. Unlock the cable clampers to free the cable.
3. Disconnect the connectors (A1, A6, A11 and A14).
4. Disconnect the flexible cables (A20, A31 and A32).
5. Remove the screws (×3 ) and remove the Tuner unit.
To Next Page
Loading...
