Panasonic TC-P50ST30

26
9.14. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2 and CB3).
2. Disconnect the flexible cable (C10).
3. Disconnect the connector (C14).
4. Remove the screws (×3 ) and remove the C1-Board.
9.15. Remove the C2-Board
1. Remove the Stand bracket. (See section 9.13.)
2. Disconnect the flexible cables (CB4, CB5, CB6, CB7,
CB8 and CB9).
3. Disconnect the flexible cables (C20, C21 and C26).
4. Remove the screws (×4 ) and remove the C2-Board.
9.16. Remove the C3-Board
1. Remove the Stand bracket. (See section 9.13.)
2. Disconnect the flexible cables (CB10, CB11, CB12,
CB13, CB14 and CB15).
3. Disconnect the flexible cables (C31, C33 and C36).
4. Disconnect the connector (C35).
5. Remove the screws (×4 ) and remove the C3-Board.
9.17. Remove the Chassis support
metal and the M8 nut metals
1. Remove the Stand bracket. (See section 9.13.)
2. Remove the screws (×3 each) and remove the Chas-
sis support metal (L, R) and the M8 nut metal top (L, R).
3. Remove the screw (×1 each) and remove the M8 nut
metal bottom (L, R).
9.18. Remove the S-Board
1. Remove the screws (×2 ) and remove the S-Board
unit.
2. Remove the screws (×2 ).
3. Disconnect the connector (S10) and remove the S-Board
from the Power button bracket.
9.19. Remove the Contact metal bot-
tom B
1. Remove the Stand bracket. (See section 9.13.)
2. Remove the screws (×7 , ×7 , ×1 ).
3. Remove the Contact metal bottom B.