19
9.2. Disassembly Procedure for the Unit
9.2.1. Remove the Pedestal stand
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the screws (×4 ).
3. Slide the Pedestal stand to the downside and remove the
Pedestal stand.
9.2.2. Remove the Stand bracket cover
1. Remove the screws (×4 ) and remove the Stand
bracket cover.
9.2.3. Remove the AC cord clamper B
1. Remove the screws (×2 ) and remove the AC cord
clamper B.
9.2.4. Remove the Bluetooth module
1. Remove the screw (×1 ) and remove the Bluetooth
module.
9.2.5. Remove the Rear cover
1. Remove the screws (×12 , ×10 , ×2 ).
2. Remove the M8 caps (×4 ).
3. Remove the Rear cover.
9.2.6. Remove the AC inlet
Caution:
To remove AC inlet wait 1 minute after power was off for
discharge from electrolysis capacitors.
1. Disconnect the connector (P9).
2. Remove the screws (×1 , ×1 ) and remove the AC
inlet.
To Next Page
Loading...
