Panasonic TC-P55ST50 - Page 24

24
9.2.21. Remove the Contact metal bottom
B
1. Remove the screws (×6 , ×4 ).
2. Remove the Contact metal bottom B.
9.2.22. Remove the K-Board
1. Remove the screw (×1 ).
2. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
9.2.23. Remove the Cabinet assy from the
Plasma panel section.
1. Place the Cabinet assy on a flat surface of a table
(covered by a soft cloth) and a cushion.
2. Remove the screws (×16 ).
3. Remove the Cabinet assy from the Plasma panel section.
9.2.24. Remove the Contact metals
1. Remove the Tape from the Contact metals.
2. Remove the screws (×6 ).
3. Remove the Contact metal side (L, R).
4. Remove the screws (×15 ).
5. Remove the Contact metal bottom A.
9.2.25. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2 and CB3).
2. Disconnect the flexible cable (C10).
3. Disconnect the connector (C14).
4. Remove the screws (×3 ) and remove the C1-Board.