Panasonic Technics SU-CH7

Speaker cables
Other
types
of
speaker
cannot
be
connected
to
this
unit.
Match
the
four
wires
from
the
left
and
right
speaker
cables
with
the
same
colored
levers
of
the
speaker
terminales,
then
insert
the
wires
into
the
respective
terminals.
@ Twist the wire.
@ Push down on the lever, insert the bare ends of the wires, and
push up the lever. (Refer to the right)
Note:
¢Make sure the bare ends of the wires are not unraveled. (If they
are, twist them tight again.)
fx fc
eTake
care
not
to
short
the
wires.
(The
main
unit
could
be
damaged if they are shorted.)
Speaker
First connect the cables to the speakers, then to the
amplifier.
Speaker cable
(included)
Speaker Amplifier
Notice for speaker connections:
Connect each color coded wire of the speaker cable to the
corresponding color coded terminal according to the following
chart.
Polarity l
High tone |
[Lowtone || Black
External
unit
connection
:
@ DAT (digital audio tape deck)
DAT
INPUT OUTPUT
Stereo
pin cord
Amplifier
[
REC OUT
PLAY BACK
et ee
@ PHONO (turntable system)
Turntabl
OUTPUT seein
Stereo ————_. i
pin cord
Amplifier
B “GND” terminal
This terminal is for use with turntables which have a ground wire.