39
Operating peripheral equipment
Programming the remote control code
Press and hold POWER and OK together, for at least
5 seconds.
• The mode selection buttons flashes, and then release
POWER and OK.
Select the type of the component.
• The selected button lights and all others go out.
Enter the 3-digit infrared code (see pages 40-42).
• Factory default setting : Panasonic
• Press POWER to test the operation.
Notes:
• If the component does not operate with the remote control, repeat the procedure
using another code. (Some brands have multiple codes.)
• If an incorrect code is entered, or if the procedure takes longer than 30 seconds, the
programming will fail.
After selecting the type of component (step 2, above)
1
2
Press to select the code.
• The code starts from the current device.
• Press POWER button to test the operation.
• Repeat the steps until the component code is found.
It may take many attempts before the correct code is
found.
Press to store the code.
You can operate other manufacturers’ components using this TV’s remote control.
Preparations:
• Connect the power cord of the external component to the wall outlet.
• Make sure the component is turned off.
1
2
3
DTV
RCVR
DBS/CBL
AUX
VCR DVD
1 2 3
4 5 6
7 8
0
9
OK
CH
VOL
CH
VOL
+
-
OK
CH
VOL
CH
VOL
+
-
R-TUNE PROG
RETURN
MENU
PLAY FFREW
TV/VIDEO
SLEEP EXIT
SAP
1 2 3
4 5 6
7 8
0
9
A
S
P
E
C
T
M
U
T
E
R
E
C
A
L
L
F
A
V
O
R
I
T
E
STOP
PAUSE
TV/VCR
OPEN/CLOSE
DVD/VCR CH
REC
LIGHT
POWER
TV
TV
CH
VOL
CH
VOL
+
-
OK
DTV
RCVR
DBS/CBL
AUX
VCR DVD
To find a code not listed in the index
POWER
OK
CH
VOL
CH
VOL
+
-
+
To Next Page
Loading...
