Advanced settings
Normal
Normalise
0
0
2.2
Off
1/2
Black extension
AGC
Gamma
Input level
Advanced settings
0
0
0
0
0
0
2/2
W/B Low B
W/B High R
W/B Low R
W/B Low G
W/B High G
W/B High B
24
Item Effect Details
Black
extension
Less More
Adjusts the dark shades of the image in gradation.
Input level
Less More
Adjustment of parts which are extremely bright and hard to see.
(This cannot be adjusted when the input signal is Digital.)
Gamma
Down Up
S Curve 2.0 2.2 2.5
AGC
Off On
Increases the brightness of dark signal automatically.
W/B High
R
Less More
Adjusts the white balance for light red areas.
W/B High
G
Less More
Adjusts the white balance for light green areas.
W/B High
B
Less More
Adjusts the white balance for light blue areas.
W/B Low R
Less More
Adjusts the white balance for dark red areas.
W/B Low G
Less More
Adjusts the white balance for dark green areas.
W/B Low B
Less More
Adjusts the white balance for dark blue areas.
On the remote control unit, while the “Advanced settings” menu is displayed, if either the N button is pressed at any time or
the ACTION ( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.
Helpful Hint ( /
Normalise
Normalisation)
Notes:
• Carry out “W/B” adjustment as follows.
1.
Adjust the white balance of the bright sections using the “W/B High R”, “W/B High G” and “W/B High B” settings.
2. Adjust the white balance of the dark sections using the “W/B Low R”
, “W/B Low G”
and “W/B Low B” settings.
3. Repeat steps 1 and 2 to adjust.
Steps 1 and 2 affect each other’s settings, so repeat each step in turn to make the adjustment.
• The adjustment values are memorized separately for each input terminal.
• The adjustment range values should be used as an adjustment reference.
(For TH-42PH10EK/S, TH-50PH10EK/S, TH-58PH10EK)
Picture Adjustments
To Next Page
Loading...
