Panasonic TH-42PH20U - SIGNAL Menu; 3 D Y;C Filter

3D Y/C FILTER (NTSC)
ON
1/2
SIGNAL
EXTENDED LIFE SETTINGS
INPUT LABEL
SET UP
OFF
STANDBY SAVE
OFF
PC POWER MANAGEMENT
OFF
DVI-D POWER MANAGEMENT
OFF
AUTO POWER OFF
OFF
OSD LANGUAGE ENGLISH
(
US
)
COMPONENT/RGB-IN SELECT
RGB
SCREENSAVER
POWER SAVE
3D Y/C FILTER (NTSC)
COLOR SYSTEM
SIGNAL
ON
AUTO
3 : 2 PULLDOWN
OFF
[
VIDEO
]
NOISE REDUCTION
OFF
3 : 2 PULLDOWN
SIGNAL
OFF
[
Digital
]
NOISE REDUCTION
OFF
H-FREQ.
V-FREQ.
kHz
Hz
63.98
60.02
DOT CLOCK FREQ. MHz108.0
SIGNAL FORMAT 1280×1024/60
SIGNAL
[
COMPONENT
]
XGA MODE
AUTO
NOISE REDUCTION
OFF
H-FREQ.
V-FREQ.
kHz
Hz
63.98
60.02
SIGNAL FORMAT 1280×1024/60
SYNC
3 : 2 PULLDOWN
AUTO
OFF
SYNC
SIGNAL
H-FREQ.
V-FREQ.
kHz
Hz
63.98
60.02
SIGNAL FORMAT 1280×1024/60
[
RGB
]
3 : 2 PULLDOWN
XGA MODE
NOISE REDUCTION
OFF
AUTO
OFF
AUTO
40
Press to select the menu to adjust.
Press to adjust the menu.
Press to exit from adjust mode.
Note:
“SIGNAL” setup menu displays a different setting condition for each input signal.
3
4
SET UP for Input Signals
SIGNAL menu
For VIDEO (S VIDEO)
3D Y/C FILTER – For NTSC AV images
This menu is displayed when BNC Dual Video Terminal Board (TY-FB9BD) is installed to the unit.
Select “SIGNAL” from the “SET UP” menu during Video (S Video) input signal mode.
(“SIGNAL [VIDEO]” menu is displayed.)
Note:
When ON, this setting only affects NTSC input signals.
Press to select the “3D Y/C FILTER (NTSC)”.
Press to set ON / OFF.
Press to display the SET UP menu.
Press to select the “SIGNAL”.
Press to display the SIGNAL menu.
2
1
For RGB
For COMPONENT For Digital
Press ACTION (
) button