Panasonic TH-50C300K - Test and Alignment; Factory Menu Description

TH-50C300K/TH-50C300M/TH-50C300S/TH-50C300T/TH-50C300X
8
5 Test and Alignment
5.1. Factory Menu Description
Follow the below steps to pop-up the Factory menu in case of “FactoryKey” is disabled:
• Press RCU “MENU” key to display main menu
•Select “Picture” and press “OK” key to enter into Picture submenu
• Scroll down to “Contrast” item
• Press the subsequence RCU keys “9”, “7”, “3” and “5”
In case of “FactoryKey” is enabled, just press RCU “Return” key to pop-up again the Factory menu.
The status of “Factory Key” can be changed in “Factory Menu->Hotkey”
• Press RCU “OK/g” key to enter the submenu.
• Press RCU “Menu” key to go back to the root menu.
• Press RCU “f/g” key to change the values.
• Press RCU “OK” key run the function.
• Press RCU “Exit” key exit the Factory menu.
1 - Hotkey submenu
2 - Warm-Up Mode submenu
3 - ADC submenu (N/A - menu reains grayed)
4 - White Balance submenu
Item Sub-item Value Note
Hotkey Off/On Enable Hotkey flag by
pressing “fg” key to have
possibility to access Fac-
tory menu with “RETURN”
key (default is disabled)
Item Sub-item Value Note
Burning
Mode
Off/On Enable Burning mode by
pressing “fg” key, then
press “EXIT” key to activate
it Press “Menu” key on
local keyboard to exit the
Burning mode
Item Sub-item Value Note
White Balance Source HDMI/VGA/DTV
PAL/SECAM
NTSC/RGB/CMP
Select by pressing “fg”
key
Color Temperature Normal/Warm/Cool Select Tone by pressing
“fg” key
RED Gain 000..255 Set R Gain by pressing
“fg” key (-127..+128 for
offset)
GREEN Gain 000..255 Set G Gain by pressing
“fg” key (-127..+128 for
offset)
BLUE Gain 000..255 Set B Gain by pressing
“fg” key (-127..+128 for
offset)
RED Offset 000..255 Set R Offset by pressing
“fg” key (-127..+128 for
offset)