Panasonic TH-50C300K - Page 9

TH-50C300K/TH-50C300M/TH-50C300S/TH-50C300T/TH-50C300X
9
5 - Reset Shop submenu
GREEN Offset 000..255 Set G Offset by pressing
“fg” key (-127..+128 for
offset)
BLUE Offset 000..255 Set B Offset by pressing
“fg” key (-127..+128 for
offset)
White Balance Init > Press “g” key to initialize
RGB
Gain/Offset values
Pic. Enhance On/Off Press “g” key to disable
all picture settings from
Feature submenu. This
should be done before
any White Balance
alignment (flag is restored
to Off after Shop-End)
Picture Related > Press “g” key to activate
submenu
Picture
Related
Flesh tone On/Off Press “fg” key to enable/
disable
Adaptive Luma Control On/Off Press “fg” key to enable/
disable
Light Sensor On/Off Press “fg” key to enable/
disable
Dynamic Backlight Low
Medium
High
Auto
Select by pressing “fg”
key
Back light 000..100 Set Backlight by pressing
“fg” key
ADP Control Low Point 000..100 (007d) Set ADP Low by pressing
“fg” key
ADP Control Middle Point 000..100 (057d) Set ADP id by pressing
“fg” key
ADP Control High Point 000..100 (100d) Set ADP High by pressing
“fg” key
Scaling Brightness 000..255 Set ScBrigh by pressing
“fg” key (-127..+128 for
offset)
Scaling Contrast 000..255 Set ScCont by pressing
“fg” key (-127..+128 for
offset)
Scaling Saturation 000..255 Set ScSat by pressing
“fg” key (-127..+128 for
offset)
Item Sub-item Value Note
Item Sub-item Value Note
Reset
Shop
> Press “OK g” key to
remove Factory presets
(channel Maps, bargraph
context, …) and restore
User OOB settings. All
adjustments are not
impacted!