■ Preventing the TV from falling over
It is recommended to secure the pedestal to a furniture as shown to prevent the TV from falling over.
●
This information is designed to reduce the risk of injuries caused by the TV falling over. However, no measure can
guarantee protection in all cases.
Band
Screw
Wood screw
F
G
H
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV.
1 Remove the assembly screws
from the cover.
2 Pull out the cover.
3 Lift the TV from the pedestal.
4 Remove the assembly screws from the bracket.
Connections
●
External equipment and cables shown are not supplied with this TV.
●
Ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.
●
Check the type of terminals and cable plugs are correct when connecting.
●
Always use a fully wired HDMI cable.
●
Keep the TV away from electronic equipment (video equipment, etc.) or equipment with an infrared sensor.
Otherwise, distortion of image / sound may occur or operation of other equipment may be interfered.
●
Also read the manual of the equipment being connected.
Terminals
5 6
4
2
1
3
7
1
SD Card slot
2
USB 1 - 2 port
3
HDMI1 - 3
4
DIGITAL AUDIO OUT
5
AV (COMPONENT / VIDEO)
(p. 8)
6
Aerial terminal
(p. 7)
7
ETHERNET (p. 8)
To Next Page
Loading...
