Installation 1
Check the setup and accessories of the concealing
Alkaline Ionizer
In case of any deficiency, please notify your dealer or subordinate service station of Panasonic.
The main unit shall be installed under the sink and connected with the special faucet for Alkaline
Ionizer.
( Please check the position where the power plug, water stop valve and main unit are set.)
The accessories marked with
are in the deep place behind the rear panel of the sink, thus they
may be invisible.
Please check that whether the accessories are complete.
Special faucet for
Alkaline Ionizer
Main unit
Cartridge inside
Rear panel
Water stop valve for
water supply
( not included in
accessories)
Water stop valve
( attached with anti-
backflow valve)
Built-in part of the
gasket attached
with strainer
Schematic diagram of installation completion
Power plug
Power cord
Supplied Accessories
<For determination of pH level>
pH test liquid (attached with the pH Chart)
The test liquid is used to regularly measure the pH level
standard.
The acidic water with pH level of 4.0 or below will show
the same color.
Main ingredients: Ethanol/methyl red/bromothymol blue/
phenolphthalein
Installation instructions
Please check whether all the items in the final check table (P.EN26 in installation instructions) have
been ticked (finished).
pH test
liquid
Test tube
pH Chart
EN11
01_TK-AB50-ZEX_ZMA_EN.indd 10 2018/09/25 16:49:29
To Next Page
Loading...
