Purified
Adjusting pH
Low High
Water
Stop/Flow
Alkaline
Weak Acidic
Adjusting pH(3sec.)
Water signal
indicator
(blue, red)
When the water pressure is relatively high
(Please tighten the water stop valve a little bit.)
To maintain the operation of normal functions, please adjust
the water flow to about 1 cup of water (about 200 ml) per
3 seconds ~ 6 seconds. (So the filter flow is about 2.2 L ~
4 L per minute.)
The warning sound during water flowing can be muted.
Please conduct after water flowing is stopped.
Please press
Weak Acidic
until there is a warning sound of
"Pl-" (about 3 seconds).
Please press
Weak Acidic
again until there are the warning
sounds of “PI, PI, PI, PIˮ (about 3 seconds), and the
function of warning sound is enabled again.
Water signal indicator
Blue
In preparation: Flash (about 15 seconds)
Drinkable: Light up
Do not drink the water that flows out of the
main spout when the water signal indicator
is flashing.
(The water is not applicable for drinking.)
Red
In preparation: Flash (15 seconds)
Ready to use: The light is on
Open
Close
Water stop valve
Slot-type screwdriver
When the water pressure is relatively low
When the cartridge is quite new and it takes more
than 6 seconds to fill one cup of water even if the
water stop valve is completely opened, the water
pressure may be too low (lower than 100 kpa), and
the filter replacement light (red) will flash.
If the water stop valve is too tight, the water signal
indicator (blue) may be flashing rather than light up.
Under this condition, the filter replacement light
(red) may flash when the Alkaline Ionizer is in use, or
the water flow at the main spout will stop.
→ Please open the water stop valve to increase water
pressure.
When the water stops after using “purified waterˮ or
“weak acidic waterˮ, the water quality will recover to
the alkaline ion water chosen by the last time. (Please
conduct after stopping water outflow.)
→
Press
Purified
(about 3 seconds), then it will in the “priority
mode of alkaline ion waterˮ. (The original setup will be
recovered after pressing again for about 3 seconds.)
As for the priority mode of alkaline ion water
Adjustment of water pressure
How to turn off water
❶
Press
Water
Stop/Flow
again to turn off water
running.
The water run through will not stop right
away (requires about 1 second). (To avoid
great abrupt force applied to the piping)
When using “weak acidic” function,
the weak acidic water in the main unit
will be drained from the main spout
and drain outlet for about 5 seconds;
afterwards, the water outflow will stop.
(Automatic cleaning begins) (P.EN22)
After water outflow stops, return to the
“purified water” state.
( If the “priority mode of alkaline ion
water” is set as follows, it will return
to the “alkaline ion water (weak) to
(strong)” mode chosen before the use
of “weak acidic” mode.)
3
Main spout
Alkaline ion water, purified water
and weak acidic water will flow out.
Drain outlet
Outflow of drained water
(non-drinkable)
EN17
01_TK-AB50-ZEX_ZMA_EN.indd 16 2018/09/28 14:49:50
To Next Page
Loading...
