Q: External Antenna Connector
R: Expansion Bus Connector
Reference Manual “Port Replicator / Car Mounter”
Switching to the Tablet mode
A
Lift up the display so it stands perpendicular to the body.
B
Slide and hold the display release latch (A), and rotate the display
clockwise until it clicks.
Attaching the stylus to the computer
Use the tether to attach the stylus to the computer so you will not lose it.
There are holes (A) to attach it.
For model with dual touch, the tether and digitizer pen are already attached
to the computer at purchase.
C
Close as the display faces up and fi x it using the latch (B).
This computer contains a magnet and magnetic products at the locations
circled in the illustration at right. Avoid leaving metallic object or magnetic me-
dia in contact with these areas.
S: Camera
<For model with Camera>
Remove the protection seal on the camera before us-
ing the camera.
Reference Manual “Camera”
Attaching the hand strap and the shoulder strap
Attach the hand strap to any two of the corners (A) using the screws.
You can connect the shoulder strap (B) to the hand strap.
(The illustration is an example.)
CAUTION
Do not use the strap to carry a heavier weight than the computer. Other-
wise the strap may become loose by itself.
Do not use the strap if it becomes worn or damaged.
To Next Page
Loading...
