37
Installing/Removing
1 Removing the device
Turn your computer over and open the cover by sliding the latch A.
Slide and hold the latch B on the MP release lever, then turn the
MP release lever.
Remove the device by holding both sides of the device.
Handle the device as shown (holding both
sides). Otherwise, the device may be dam-
aged. Also, do not apply excessive down-
ward force on the device. The projections at
the bottom of a device become deformed.
Installing the device
Gently insert the device into the multimedia pocket by pushing on
both corners until it clicks into place.
Do not install the device upside-down.
The bottom of the drive may become disfigured.
CAUTION
CAUTION
NOTE
Cover
Latch A
MP Release Lever
Install the device with the plastic
side on top.
Latch B
Multimedia Pocket
2 Windows 98
Select [OK] on the [BaySwap] screen
Whether the device is properly recognized or not can be con-
firmed in [Main] of the Setup Utility. If the device is not recognized
(or if a CD/DVD cannot be read or an FD/HDD/CD-R/CD-RW can-
not be read or written to), power off the computer and reinstall the
device.
When the CD drive is installed:
If the vibration of the CD drive is excessive, set the [CD Drive
Speed] to [Low] in the Setup Utility.
Windows 98
If is clicked with the right button, although [Change Drive Pass-
word] is displayed it cannot be selected.
To Next Page
Loading...
